Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE
Fuel Pressure Sensor: Removal
- PRECAUTIONÂ CAUTION:
- Do not smoke or work near an open flame when handling the fuel system.
- Keep gasoline away from rubber or leather parts.
- Do not allow fuel to spray when removing the pipe between the high pressure side fuel pump assembly and the fuel injector assembly. The fuel in the pipe is highly pressurized.
- DISCHARGE FUEL SYSTEM PRESSUREÂ
- Discharge fuel system pressure (See FUEL SYSTEMÂ ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINALÂ NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
- REMOVE INTAKE AIR SURGE TANK ASSEMBLYÂ
- Remove the intake air surge tank assembly (See REMOVAL ).
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLYÂ (See REMOVALÂ )
- REMOVE FUEL PRESSURE SENSORÂ
- Disconnect the connector.
- Remove the fuel pressure sensor and gasket
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
