2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Certification ECU Right side of trunk. See Figure.
Clearance Warning ECU Left side of trunk. See Figure.
Cooling Fan ECU Behind left radiator cooling fan motor. See Figure.
Cooling Fan ECU No. 2 Behind right radiator cooling fan motor. See Figure.
Distance Control ECU Behind left side of dash. See Figure.
ECM (Engine Control Module) Left front of engine compartment. See Figure.
Front Position Control ECU & SW (LH) Below left side of driver's seat. See Figure.
Front Position Control ECU & SW (RH) Below right side of front passenger's seat. See Figure.
Headlight Swivel ECU Left kick panel. See Figure.
Main Body ECU (LH) In left cowl side junction block. See Figure.
Main Body ECU (RH) In right cowl side junction block. See Figure.
Multiplex Tilt & Telescopic ECU On steering column. See Figure.
Network Gateway ECU At right end of dash. See Figure.
Occupant Detection ECU Under front passenger's seat. See Figure.
Outer Mirror Control ECU (Left/Right) In respective front doors. See Figure.
Overhead Module Center front of roof. See Figure.
Power Source Control ECU Behind right side of dash. See Figure.
Power Steering ECU Right rear of engine compartment. See Figure.
Seat Belt Control ECU Left side of trunk. See Figure.
Seat Heater Control Sub-Assembly (Left) (U3) Under driver's seat. See Figure.
Seat Heater Control Sub-Assembly (Right) (T2) Under right front seat. See Figure.
Shift Lock Control ECU Under center console. See Figure.
Skid Control ECU Behind right side of dash. See Figure.
Sliding Roof Control ECU Center front of roof. See Figure.
Tire Pressure Warning ECU & Receiver Behind center of dash. See Figure.
Transmission Control ECU Left side of engine compartment. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.