Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Slip Indicator Light Remains ON: Description
The skid control ECU is connected to the combination meter via the CAN and multiplex communication systems
The slip indicator light blinks during VSC and/or TRAC operation
When the system malfunctions, the slip indicator light comes on to warn the driver (See DIAGNOSIS SYSTEMΒ ). Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls If traction control is turned off, the slip indicator light will come on
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
