Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor: Installation
- INSTALL CAMSHAFT POSITION SENSOR
- Install the camshaft position sensor with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the camshaft position sensor connector
- Install the camshaft position sensor with the bolt.
- INSTALL VVT SENSOR (for Bank 1)
- Install the 2 VVT sensors with the 2 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the VVT sensor connectors.
- Connect the 3 wire harness clamps.
- Install the 2 VVT sensors with the 2 bolts.
- INSTALL VVT SENSOR (for Bank 2)
- Install the 2 VVT sensors with the 2 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the VVT sensor connectors
- Connect the wire harness clamp
- Install the 2 VVT sensors with the 2 bolts.
- INSPECT FOR OIL LEAK
- INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
