Inspection Procedure

1. Connect the Techstream to the DLC3
2. Turn the engine switch on (IG).
3. Turn the Techstream ON
4. Clear DTCs (See DTC CHECK/CLEAR )
5. Turn the engine switch to off and turn the Techstream off
6. Disconnect the Techstream
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) battery terminal
9. Connect the Techstream to the DLC3
10. Turn the engine switch on (IG).
11. Turn the Techstream ON
12. Enter the following menus Powertrain / Engine / Trouble Codes
13. Read the DTCs

    Result 

    RESULT CHART
    
    

    Result	Proceed to
    DTC is not output	A
    DTC P060B is output	B
    DTC P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D are output	C

B: REPLACE ECM  (See REMOVAL )

C: GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D)  (See DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW INPUT (BANK 1 OR SINGLE SENSOR); DTC P0328 KNOCK SENSOR 1 CIRCUIT HIGH INPUT (BANK 1 OR SINGLE SENSOR); DTC P032C KNOCK SENSOR 3 CIRCUIT LOW; DTC P032D KNOCK SENSOR 3 CIRCUIT HIGH; DTC P0332 KNOCK SENSOR 2 CIRCUIT LOW INPUT (BANK 2); DTC P0333 KNOCK SENSOR 2 CIRCUIT HIGH INPUT (BANK 2); DTC P033C KNOCK SENSOR 4 CIRCUIT LOW INPUT; DTC P033D KNOCK SENSOR 4 CIRCUIT HIGH INPUT )

A: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS )