2008 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Service Data

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

Cold tire inflation pressure 

TIRE AND WHEEL (COLD TIRE INFLATION PRESSURE) - SERVICE DATA

Tire Size Cold tire inflation pressure kPa (kgf/cm2 , psi)
Front Rear Front Rear
225/40R19 93Y 255/35R19 96Y 250 (2.5, 36) 250 (2.5, 36)

When driving under the above vehicle conditions at sustained high speeds of above 160 km/h (100 mph), in countries where such speeds are permitted by law, inflate the front and rear tires to 310 kPa (3.1 kgf/cm2 , 45 psi) provided that it does not exceed the maximum cold tire inflation pressure molded on the tire sidewall

TIRE AND WHEEL - SERVICE DATA

Maximum tire runout 1.0 mm (0.0394 in)
Maximum wheel imbalance after adjustment 80 g (0.01761b)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.