2008 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
BRAKE CONTROL AND DYNAMIC CONTROL SYSTEMS - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Brake actuator assembly x Brake actuator bracket assembly 54 55 48 in *lbf
Brake actuator bracket assembly x Body 19 194 14
Brake actuator assembly x Brake line 14 (15) 143 (153) 10 (11)
No. 3 engine room relay block x Body 80 82 71
Rear speed sensor 85 87 75 in *lbf
Yaw rate and acceleration sensor 15 153 11
Skid control ECU 55 56 49 in *lbf

(). For use without union nut wrench

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.