Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Section 45 (Navigation): Multi-Display: Removal
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE UPPER NO. 1 CONSOLE PANEL GARNISHÂ (See REMOVAL )
- REMOVE UPPER NO. 2 CONSOLE PANEL GARNISHÂ (See REMOVAL )
- REMOVE CONSOLE PANEL SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE FRONT ASH RECEPTACLE ASSEMBLYÂ (See REMOVAL )
- REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLYÂ (See REMOVAL )
- REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANELÂ (See REMOVAL )
- REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLYÂ (See REMOVAL )
- REMOVE NO. 1 RADIO BRACKETÂ (See REMOVAL )
- REMOVE NO. 2 RADIO BRACKETÂ (See REMOVAL )
- REMOVE MULTI-DISPLAY ASSEMBLYÂ
- Slide the multi-display assembly in the direction shown by the arrow to remove the multi-display assembly
- REMOVE NAVIGATION ECUÂ (See REMOVALÂ )
- REMOVE CLOCK ASSEMBLYÂ (See REMOVAL )
- REMOVE MULTI-DISPLAYÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
