2008 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Lin Communication System: Precaution

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.
SYSTEM REFERENCE

System Name See Procedure
Power Window Control System INITIALIZATION
  1. PRECAUTIONS WHEN USING TECHSTREAM 
    1. When using the Techstream with the engine switch off to troubleshoot

      Connect the Techstream to the vehicle, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and the vehicle begins.

    2. After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG)
  2. PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK 
    1. If the steering lock ECU (steering lock actuator assembly) is replaced, open and close the driver door. The engine may not start until either operation is performed

      HINT

      Opening and closing the driver door causes the steering lock ECU (steering lock actuator assembly) to memorize the correct steering lock bar position

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.