2008 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Distance Control ECU Communication Stop Mode: Description

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTION CONDITION CHART

Detection Item Symptom Trouble Area
Distance Control ECU Communication Stop Mode
  • "Cruise Control (ACC)" is not displayed on the "CAN Bus Check" screen of the Techstream
  • Applies to "Distance Control ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  • Power source circuit of the distance control ECU
  • Distance control ECU branch line or connector
  • Distance control ECU

HINT:

"Cruise Control" refers to the circuit that includes the distance control ECU.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.