2008 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Section 39 (Audio/Visual): Microphone: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL AMPLIFIER MICROPHONE 
    1. Engage the 2 claws and install the amplifier microphone.
      Fig 1: Identifying Amplifier Microphone Claws
      G05753503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connector.
    Fig 2: Locating Amplifier Microphone Connector
    G05753502Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL MAP LIGHT ASSEMBLY (w/o Sliding Roof)  (See INSTALLATION )
  3. INSTALL MAP LIGHT ASSEMBLY (w/ Sliding Roof)  (See INSTALLATION )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.