Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS 250 RWD, StandardFACTORY OEM SERVICE PROCEDURE
Steering Angle Sensor: Installation
- INSTALL STEERING ANGLE SENSORÂ
- Align the locating pins, engage the 6 claws and install the steering angle sensor to the spiral cable sub-assembly.
- INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSORÂ (See INSTALLATION )
- INSTALL STEERING COLUMN COVERÂ (See INSTALLATION )
- INSTALL STEERING WHEEL ASSEMBLYÂ (See INSTALLATION )
- INSTALL STEERING PADÂ (See INSTALLATION )
- INSTALL NO. 3 LOWER STEERING WHEEL COVERÂ (See INSTALLATION )
- INSTALL NO. 2 LOWER STEERING WHEEL COVERÂ (See INSTALLATION )
- INSPECT STEERING WHEEL CENTER POINTÂ
- Inspect the steering wheel center point.
- CONNECT BATTERY NEGATIVE TERMINALÂ NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See INITIALIZATION )
- INSPECT STEERING PADÂ (See INSTALLATION )
- INSPECT SRS WARNING LIGHTÂ
HINT:
(See DIAGNOSIS SYSTEM )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
