Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS 250 RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
HINT
- The vehicle stability control system troubleshooting procedure is based on the premise that the multiplex communication system is operating normally. Check the multiplex communication system first before troubleshooting the vehicle stability control system (See HOW TO PROCEED WITH TROUBLESHOOTING )
- *. Use the Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
- CUSTOMER PROBLEM ANALYSISÂ
- Interview the customer and confirm the problem (See HOW TO PROCEED WITH TROUBLESHOOTING )
- CHECK DTC AND FREEZE FRAME DATA*Â
- Check and record DTCs and Freeze Frame Data
- Clear the DTCs and Freeze Frame Data (See DTC CHECK / CLEARÂ for DTC Check/Clear, and FREEZE FRAME DATAÂ for Freeze Frame Data).
- Reconfirm the DTCs
- Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (See DTC CHECK / CLEARÂ
for DTC Check/Clear, and FREEZE FRAME DATAÂ
for Freeze Frame Data).
HINT:
- When DTCs indicating CAN communication system malfunctions are output, repair the CAN communication system before repairing each corresponding sensor (See HOW TO PROCEED WITH TROUBLESHOOTING ).
- If any of DTCs U0100/65, U0123/62, U0124/95, and U0126/63 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (See CHECK FOR INTERMITTENT PROBLEMSÂ
)
ResultÂ
RESULT REFERENCEResult Proceed to DTC is output A DTC is not output (Problem symptom does not occur) B DTC is not output (Problem symptom occurs) C
- Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (See DTC CHECK / CLEARÂ
for DTC Check/Clear, and FREEZE FRAME DATAÂ
for Freeze Frame Data).
B: Go to step  5
C: Go to step  6
A: Go to next stepÂ
- DIAGNOSTIC TROUBLE CODE CHARTÂ
- Proceed to DIAGNOSTIC TROUBLE CODE CHARTÂ .
NEXT: Go to step  7
- SYMPTOM SIMULATIONÂ
- Proceed to DIAGNOSIS SYSTEMÂ
- PROBLEM SYMPTOMS TABLEÂ
- Proceed to PROBLEM SYMPTOMS TABLEÂ .
- CIRCUIT INSPECTION*Â
- IDENTIFICATION OF PROBLEMÂ
- REPAIR OR REPLACEMENTÂ
- CONFIRMATION TEST*Â
NEXT: ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
