Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus GX 470FACTORY OEM SERVICE PROCEDURE
On-Vehicle Inspection
- INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
- Warm up the engine.
- Turn the ignition switch OFF.
- Connect Techstream to the DLC3.
- Turn the ignition switch ON (IG).
- Turn the tester on.
- Enter the following menus:
Select: Powertrain/Engine and ECT/Active Test/Control the VVT System (Bank 1).
- Check the engine speed when the OCV is operated by the Techstream.
Idle speed:
650 to 750 rpm OK
SPECIFIED CONDITIONCondition Specified Condition VVT system is OFF (OCV is OFF) Normal engine speed VVT system is ON (OCV is ON) Rough idle or engine stalled
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
