2008 Lexus GS 460FACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES LOCATION

Component Location
Center J/B LH Behind right side of dash. See Figure.
Center J/B RH Behind right side of dash. See Figure.
Cowl Side J/B LH Behind left side of dash. See Figure.
Cowl Side J/B RH Behind right side of dash. See Figure.
Engine Room J/B No. 1 Right rear of engine compartment. See Figure.
Engine Room J/B No. 2 Left side of engine compartment. See Figure.
Engine Room R/B No. 1 Right rear of engine compartment. See Figure.
Engine Room R/B No. 2 Left side of engine compartment. See Figure.
Engine Room R/B No. 3 (3.5L) Left rear of engine compartment. See Figure.
Engine Room R/B No. 3 (4.6L) Left rear of engine compartment. See Figure.
Engine Room R/B No. 4 Right side of engine compartment. See Figure.
Fusible Link Block Right side of luggage compartment. See Figure.
Luggage Room J/B Left side of luggage compartment. See Figure.
Luggage Room R/B No. 6 Right rear corner of luggage compartment. See Figure.
Overhead J/B In overhead console. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.