Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
*: Use the intelligent tester.
- VEHICLE BROUGHT TO WORKSHOPÂ
- CUSTOMER PROBLEM ANALYSISÂ
- Interview the customer and confirm the trouble (See HOW TO PROCEED WITH TROUBLESHOOTING ).
- CHECK DTC AND FREEZE FRAME DATA*Â
- Check and record a DTC and Freeze Frame Data.
- Clear the DTC and Freeze Frame Data (See DTC CHECK / CLEARÂ , or FREEZE FRAME DATAÂ ).
- Reconfirm the DTC.
- Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (See
DTC CHECK/CLEARÂ , or
FREEZE FRAME DATAÂ ).
HINT:
If any of the DTCs U0100/65, U0123/62, U0124/95, and U0126/63 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (See CHECK FOR INTERMITTENT PROBLEMSÂ ).
ResultÂ
RESULT CHARTCondition Proceed to DTC is output A DTC is not output (Problem symptom does not occur) B DTC is not output (Problem symptom occurs) C
- Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (See
DTC CHECK/CLEARÂ , or
FREEZE FRAME DATAÂ ).
B: GO TO STEPÂ Â 5
C: GO TO STEPÂ Â 6
A: Go to Next StepÂ
- DIAGNOSTIC TROUBLE CODE CHARTÂ
- Proceed to DIAGNOSTIC TROUBLE CODE CHARTÂ .
NEXT: GO TO STEPÂ Â 7
- SYMPTOM SIMULATIONÂ
- Proceed to DIAGNOSIS SYSTEMÂ .
- PROBLEM SYMPTOMS TABLEÂ
- Proceed to PROBLEM SYMPTOMS TABLEÂ .
- CIRCUIT INSPECTION*Â
- IDENTIFICATION OF PROBLEMÂ
- REPAIR OR REPLACEMENTÂ
- CONFIRMATION TEST*Â
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
