2008 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Skid Control Sensor: Inspection

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT SKID CONTROL SENSOR 
    1. Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:
      • The surface of the skid control sensor is cracked, dented, or chipped off.
      • The connector is scratched, cracked, or damaged.
      • The skid control sensor has been dropped.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance: 

      RH 

      RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      2 (RR+) - 1 (RR-) Always 0.9 to 2.1 kΩ
      2 (RR+) - Body ground Always 10 kΩ or higher
      1 (RR-) - Body ground Always 10 kΩ or higher

      LH 

      RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      2 (RL+) -1 (RL-) Always 0.9 to 2.1 kΩ
      2 (RL+) - Body ground Always 10 kΩ or higher
      1 (RL-) - Body ground Always 10 kΩ or higher

      If the value is not as specified, replace the skid control sensor.

      Fig 1: Measuring Resistance Between Skid Control Sensor Terminal And Body
      G05250499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.