2008 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

STEERING COLUMN ASSEMBLY 

STEERING COLUMN - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Steering intermediate shaft assembly x Steering column assembly 35 360 26
Steering column assembly set nuts 21 214 16
Steering column assembly set bolt 21 214 16
Steering intermediate shaft assembly x Power steering link assembly 35 360 26
Front wheel LH set nuts 103 1,050 76
Lower steering column cover x Upper steering column cover 2.0 20 18 in.*lbf
Steering wheel assembly set nut 50 510 37
Multiplex tilt and telescopic ECU set screws 1.5 15 13 in.*lbf
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.