Data List / Active Test

HINT:

Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful as intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

1. Connect Techstream to the DLC3.

   When using Techstream with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 or less second intervals until communication between the tester and vehicle starts.

2. Turn the engine switch on (IG).
3. Enter the following menus: DIAGNOSIS / OBD/ MOBD / DATA LIST.
4. Read the DATA LIST.

   Main Body: 

   DIAGNOSTIC NOTE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ACC SW	Engine switch on (ACC) / ON or OFF	ON: Engine switch on (ACC) OFF: Engine switch off	-
   IGSW	Engine switch on (IG) / ON or OFF	ON: Engine switch on (IG) OFF: Engine switch off	-
   Stop Light SW	Stop light switch / ON or OFF	ON: Brake pedal depressed OFF. Brake pedal released	-
   Start Switch 1	Start switch 1 / ON or OFF	ON: Engine switch is pushed OFF. Engine switch is not pushed	-
   Start Switch 2	Start switch 2 / ON or OFF	ON: Engine switch is pushed OFF: Engine switch is not pushed	-
   Steering Unlock Switch	Steering lock condition / ON or OFF	ON: Steering is unlocked (Engine switch on (ACC)) OFF Steering is locked (Engine switch off)	-
   Neutral SW / Clutch SW	Park/Neutral position switch / ON or OFF	ON. Shift position is P or N OFF: Shift position is except P and N	-
   Shift P Signal	Shift P position signal / ON or OFF	ON: Shift position is P OFF. Shift position is not P	-
   Vehicle Speed Signal	Vehicle speed signal / STOP or RUN	STOP: Vehicle is stopped RUN: Vehicle is running	-
   Engine Condition	Engine condition / STOP or RUN	STOP: Engine is stopped RUN Engine is running	-
   IG1 Relay Monitor (Outside)	IG1 relay monitor (outer) / ON or OFF	ON Engine switch on (IG) OFF: Engine switch off	-
   IG2 Relay Monitor (Outside)	IG2 relay monitor (outer) / ON or OFF	ON: Engine switch on (IG) OFF Engine switch off	-
   IG1 Relay Monitor (Inside)	IG1 relay monitor (inner) / ON or OFF	ON: Engine switch on (IG) OFF Engine switch off	-
   IG2 Relay Monitor (Inside)	IG2 relay monitor (inner) / ON or OFF	ON: Engine switch on (IG) OFF. Engine switch off	-
   ACC Relay Monitor	ACC relay monitor/ ON or OFF	ON: Engine switch on (ACC) OFF Engine switch off	-
   Latch Circuit	Latch circuit / ON or OFF	ON. Engine switch on (IG) or engine running OFF: Engine switch off or on (ACC)	-
   Starter Request Signal	Starter request signal monitor / ON or OFF	ON. Starter relay is ON OFF: Starter relay is OFF	Engine switch pressed and held with shift lever in P or N
   Power Supply Condition	Power supply condition / ALL, ACC ON, IG1 IG2, ST ON	ALL All relays are OFF ACC ON: ACC relay is ON IG1. IG1 relay is ON IG2: IG2 relay is ON ST ON: ST request signal is ON	-
   ACC Relay Cut Signal	ACC relay cut signal / ON or OFF	ON: Engine is cranking OFF: Engine is not cranking	-
   Starter Relay Monitor	STARTER relay monitor / ON or OFF	ON: Engine is cranking OFF: Engine is not cranking	Engine is cranking with engine switch on (IG) and shift lever in P or N
   Communication Smart/Wireless	Communication for certification ECU / OK or STOP	OK: Communication STOP. No communication	-

HINT:

Performing Techstream ACTIVE TEST allows the relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

1. Connect Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST.
4. Perform the ACTIVE TEST according to the display on the tester.

   Main Body: 

   DIAGNOSTIC NOTE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicator for Lighting	Indicator for lighting	ON/OFF	-
   Indicator Condition	Engine switch indicator	Green / Amber / No Sig	-
   P Supply for Steering Lock	Power supply for steering lock ECU	ON/OFF	-