2008 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Power Window Regulator Motor: Installation

  1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY  (See REASSEMBLY )
  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY  (See REASSEMBLY )
  3. INSTALL REAR DOOR GLASS RUN  (See REASSEMBLY )
  4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY  (See REASSEMBLY )
  5. INSTALL REAR DOOR QUARTER WINDOW GLASS  (See REASSEMBLY )
  6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY  (See REASSEMBLY )
  7. INSTALL REAR DOOR TRIM BRACKET  (See REASSEMBLY )
  8. INSTALL REAR DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  9. INSTALL REAR DOOR FRAME GARNISH  (See REASSEMBLY )
  10. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP  (See REASSEMBLY )
  11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
  12. INSTALL REAR DOOR ARMREST COVER  (See REASSEMBLY )
  13. INSTALL COURTESY LIGHT ASSEMBLY  (See REASSEMBLY )
  14. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY  (See REASSEMBLY )
  15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG  (See REASSEMBLY )
  16. INITIALIZATION POWER WINDOW CONTROL SYSTEM 

    (See INITIALIZATION  )

  17. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY  (See REASSEMBLY )
  18. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY  (See REASSEMBLY )
  19. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY  (See REASSEMBLY )
  20. INSTALL FRONT DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  21. INSTALL FRONT NO. 1 DOOR TRIM BRACKET  (See REASSEMBLY )
  22. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY  (See INSTALLATION )
  23. INSTALL OUTER MIRROR PROTECTOR  (See REASSEMBLY )
  24. INSTALL DOOR FRAME GARNISH  (See REASSEMBLY )
  25. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP  (See REASSEMBLY )
  26. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
  27. INSTALL DOOR ARMREST COVER  (See REASSEMBLY )
  28. INSTALL COURTESY LIGHT ASSEMBLY  (See REASSEMBLY )
  29. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY  (See REASSEMBLY )
  30. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See REASSEMBLY )
  31. INITIALIZE POWER WINDOW CONTROL SYSTEM 

    (See INITIALIZATION  )

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.