2008 Lexus ES 350 V6-3.5L (2GR-FE)FACTORY OEM SERVICE PROCEDURE

Removal








2GR-FE ENGINE CONTROL SYSTEM: ECM:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE ROOM SIDE COVER RH Removal

5. REMOVE FRONT SUSPENSION UPPER CENTER BRACE Removal

6. REMOVE ECM

Factory service manual diagram





(a) Remove the 3 nuts.
(b) Disconnect the 2 ECM connectors and remove the ECM.

Factory service manual diagram




(1) Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter do not contact the connecting part of the connector.
(2) Remove the ECM.

Factory service manual diagram





(c) Remove the 4 screws and 2 ECM brackets.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.