Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus ES 350 V6-3.5L (2GR-FE)FACTORY OEM SERVICE PROCEDURE
Installation
MIRROR: OUTER MIRROR CONTROL ECU:
INSTALLATION
1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY
(a) Install the outer mirror control ECU assembly with the nut.
(b) Connect the 2 connectors.
2. INSTALL LOWER INSTRUMENT PANEL RH Installation
3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation
4. INSTALL SIDE INSTRUMENT PANEL RH Installation
5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
6. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation
7. INSTALL FRONT DOOR SCUFF PLATE RH Installation
8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.
11. INSPECT SRS WARNING LIGHT Diagnosis System
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.