Basic Inspection

When the malfunction is not confirmed page IN-3 by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.

1. CHECK BATTERY VOLTAGE 
   NOTE: Perform this check with the engine stopped and the ignition switch OFF.
   RESULT CHART
   
   

   Result	Proceed to
   11 V or more	OK
   Below 11 V	NG

   NG: CHARGE OR REPLACE BATTERY 

   OK: Go to next step 

2. CHECK WHETHER ENGINE WILL CRANK 

   NG: PROCEED TO PROBLEM SYMPTOMS TABLE 

   OK: Go to next step 

3. CHECK WHETHER ENGINE STARTS 

   NG: GO TO STEP  6

   OK: Go to next step 

4. CHECK AIR FILTER 
   1. Visually check that the air filter is not excessively contaminated with dirt or oil.

   NG: REPLACE AIR FILTER 

   OK: Go to next step 

5. CHECK IDLING SPEED 

   NG: PROCEED TO PROBLEM SYMPTOMS TABLE 

   OK: Go to next step 

6. CHECK FUEL PRESSURE 

   NG: PROCEED TO TROUBLESHOOTING 

   OK: Go to next step 

7. CHECK FOR SPARK 

   NG: PROCEED TO TROUBLESHOOTING 

   OK: PROCEED TO PROBLEM SYMPTOMS TABLE