2007 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

NOTE:
  • Perform the MAF meter inspection according to the procedures below.
  • Only replace the MAF meter when both the LONG FT#1 value and MAF value in the DATA LIST (with the engine stopped) are not within the normal operating range.
  1. INSPECT MASS AIR FLOW METER 
    1. Perform confirmation driving pattern.
      1. Connect the intelligent tester to the DLC3.
      2. Turn the ignition switch ON.
      3. Turn the tester ON.
      4. Clear the DTCs (see DTC CHECK/CLEAR  ).
      5. Start the engine and warm it up with all accessory switches OFF until the engine coolant temperature is 75°C (167°F) or more.
      6. Drive the vehicle at 50 km/h (31 mph) or more for 3 to 5 minutes*1.
      7. Allow the engine to idle for 2 minutes*2.
      8. Perform steps *1 and *2 at least 3 times.
        Fig 1: Connecting Intelligent Tester To DLC3
        G05291569Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.