Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Vehicle Inspection
- CHECK CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
- Check the operation.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON.
- Turn the intelligent tester main switch ON.
- Start and warm up the engine.
- Select the menu items: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / VVT CTRL B1.
- Operate the OCV using the intelligent tester, and then check the engine speed.
Standard condition
TESTER CONDITION SPECIFIED CONDITION REFERENCE CHARTTester Operation Specified Condition Oil control valve is OFF Normal engine speed Oil control valve is ON Rough idling or engine stalls If the operation is not as specified, check the oil control valve, wire harness and ECM.
- Check the operation.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.