Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Charging Systems: Charging: Generator: Replacement
- REPLACE FRONT BEARING
- Remove the 4 screws and bearing retainer.
- Using SST and a press, press out the bearing.
SST 09223-00010
- Using SST and a press, press in a new bearing.
SST 09950-60010
- Install the bearing retainer with the 4 screws.
Torque: 2.3 N*m (24 kgf*cm, 20 in.*lbf)
- REPLACE REAR BEARING
- Using SST, remove the bearing cover (outside) and bearing.
SST 09820-00021
NOTE: Be careful not to damage the fan. - Remove the bearing cover (inside).
- Place the bearing cover (inside) on the rotor.
- Using SST and a press, press in a new bearing.
SST 09820-00031
- Using SST, push in the bearing cover (outside).
SST 09285-76010
- Using SST, remove the bearing cover (outside) and bearing.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.