Freeze Frame Data

HINT:

• When a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
• The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to ON since the last time the ABS was activated. However, if the vehicle is stopped, the vehicle is driven at 7 km/h (4.3 mph) or less, or a DTC is detected, the ECU will not count the next time the ignition switch is turned from OFF to ON.
• Freeze frame data at the time the ABS operates: The skid control ECU stores data or updates stored data when the ABS operates. This data is erased when the ECU stores data at the time a DTC is detected.
• Freeze frame data at the time a DTC is detected: When the ECU stores data at the time a DTC is detected, the data will not be updated until the data is cleared.

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the ignition switch ON.
3. From the display on the tester, select Freeze Frame Data.
   FREEZE FRAME DATA
   
   

   Intelligent Tester Display	Measurement Item	Reference Value
   VEHICLE SPD	Wheel speed sensor reading	Speed indicated on speedometer
   STOP LIGHT SW	Stop light switch signal	Stop light switch ON: ON Stop light switch OFF: OFF
   #IGON	Number of operations of ignition switch ON after memorizing freeze frame data	0 to 31
   MAS CYL PRESS 1	Master cylinder pressure sensor output voltage	Release brake pedal: 0.3 to 0.9 V Depress brake pedal: 3.2 to 4.5 V
   MAS PRESS GRADE	Master cylinder pressure sensor changing declivity	-30 to 200 MPa/s
   SYSTEM	Operate system	ABS activated: ABS BA activated: BA VSC (TRAC) operate: VSC (TRC) No system activated: No SYS Fail-safe mode activated: FAIL SF
   YAW RATE	Yaw rate angle sensor output value	-70 to 70
   STEERING ANG	Steering sensor output value	Left turn: Increase Right turn: Drop
   THROTTLE	Throttle position sensor output value	Release accelerator pedal: Approx. 0° Depress accelerator pedal: Approx. 90°
   G (RIGHT & LEFT)	Right and left G	-1.5 to 1.5
   G (BACK & FORTH)	Back and forth G	-1.5 to 1.5
   SHIFT POSITION	Shift lever position	P: P* R: R N: N* D: D
   TRAC/VSC OFF M	TRAC/VSC Off Mode	Normal mode TRAC OFF mode VSC OFF mode
   HINT: *: The A/C switch is OFF and all accessory switches are OFF.