Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Speed Sensor: Installation
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- INSTALL FRONT SPEED SENSOR LH
- Install the sensor with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- Install the sensor harness with the 2 clamp bolts and resin clip.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
- Connect the sensor connector.
- Install the sensor with the bolt.
- INSTALL FRONT FENDER LINER LH
- INSTALL FRONT WHEEL
- Install the wheel with the 5 nuts.
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
- Install the ornament with the 10 bolts.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
- Install the wheel with the 5 nuts.
- CHECK ABS SPEED SENSOR SIGNAL
- Check the ABS speed sensor signal (see TEST MODE PROCEDURE ).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.