2007 Lexus RX 400h FWDFACTORY OEM SERVICE PROCEDURE

Typical Malfunction Thresholds

Functional check:Β 

TYPICAL MALFUNCTION THRESHOLDS

Either of following conditions 1 or 2 met -
1. Frequency that following conditions (a) and (b) met 5 time or more
(a) Engine RPM - target engine RPM Below -100 rpm, or more than 150 rpm
(b) Vehicle condition Stop after vehicle was driven by 10 km/h (6.25 mph) or more
2. Frequency that following conditions (a) and (b) met Once
(a) Engine RPM - target engine RPM Below -100 rpm, or 150 rpm or more
(b) ISC airflow rate (learning value) 1.3 L/sec. or less, or 9.24 L/sec. or more
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.