Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus RX 400h FWDFACTORY OEM SERVICE PROCEDURE
Front Speed Sensor: Removal
- REMOVE FRONT WHEEL
- REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY
- Remove the bolts, screws, clips and front fender splash shield sub-assembly.
- REMOVE FRONT SPEED SENSOR
- Disconnect the front speed sensor connector.
- Remove the 2 bolts from the body and the shock absorber assembly.
- Remove the clamp from the steering knuckle.
- Remove the bolt and the front speed sensor.
NOTE:- Prevent foreign matter from attaching to the sensor tip.
- Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.