2007 Lexus RX 350 FWDFACTORY OEM SERVICE PROCEDURE

Check Mode Procedure

HINT:

Intelligent tester only:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.

NOTE: All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned off or turned to the ACC position from the ON position while in check mode.
Before changing modes, always check and make a note of any DTCs and freeze frame data.
  1. CHECK MODE PROCEDURE (Using an intelligent tester) 
    1. Check and ensure the following conditions:
      1. Battery voltage 12 V or more
      2. Throttle valve fully closed
      3. The shift lever in the P or N position
      4. A/C switched OFF
    2. Turn the ignition switch off.
    3. Connect an intelligent tester to the DLC3.
    4. Turn the ignition switch to the ON position.
    5. Turn the tester ON.
    6. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / CHECK MODE.
    7. Switch the ECM from normal mode to check mode.
      Fig 1: Connecting Intelligent Tester To DLC3
      G05267987Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Make sure that the MIL flashes as shown in the illustration.
    9. Start the engine.
    10. Make sure that the MIL goes off.
    11. Simulate the conditions of the malfunction described by the customer.
    12. Check for DTCs and freeze frame data using the tester.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.