Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus RX 350 FWDFACTORY OEM SERVICE PROCEDURE
Fuel Injector: Installation
- INSTALL FUEL INJECTOR ASSEMBLY
- Apply a light coat of spindle oil or gasoline to new O-rings, and install them to each injector.
- Apply a light coat of spindle oil or gasoline where the fuel delivery pipe contacts the O-ring.
- Push the fuel injector while turning it to install the injector in the fuel delivery pipe.
- Position the fuel injector connector outward.NOTE:
- Be careful not to twist the O-ring.
- After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
