Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus RX 350 AWDFACTORY OEM SERVICE PROCEDURE
Terminals Of Ecu
- CHECK AIR CONDITIONING AMPLIFIER ASSEMBLYΒ
Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
- Measure the voltage and resistance of each terminal of the connectors.CONNECTOR TERMINAL VOLTAGE SPECIFICATION
Symbols (Terminal No) Wire Color Terminal Description Condition Specified Condition A8-8 (FDEF) - A8-6 (GND) B - W-B Front Deicer Signal Engine switch on (IG)
Front deicer switch ONBelow 1 V A8-8 (FDEF) - A8-6 (GND) B - W-B Front Deicer Signal Engine switch on (IG)
Front deicer switch OFF10 to 14 V A8-19 (DFG) - A8-6 (GND) G - W-B Rear Defogger Signal Engine switch on (IG)
Rear defogger switch OFF10 to 14 V A8-19 (DFG) - A8-6 (GND) G - W-B Rear Defogger Signal Engine switch on (IG)
Rear defogger switch ONBelow 1 V A8-6 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ξ©
- Measure the voltage and resistance of each terminal of the connectors.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
