Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus RX 350 AWDFACTORY OEM SERVICE PROCEDURE
Inspection Procedure
- INSPECT POWER WINDOW REGULATOR MOTOR
- Remove the power window motor.
- Apply battery voltage to the motor connector according to the table below.NOTE: Do not apply battery to any terminals except terminals 1 and 2.
Standard
VOLTAGE SPECIFICATION TABLEMeasurement Condition Specified Condition Battery positive (+) → Terminal 1 (D)
Battery negative (-) → Terminal 2 (U)Motor gear rotates clockwise Battery positive (+) → Terminal 2 (U)
Battery negative (-) → Terminal 1 (D)Motor gear rotates counterclockwise
NG: REPLACE POWER WINDOW REGULATOR MOTOR
OK: Go to next step.
- CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK MASTER SWITCH)
- Disconnect the P22 and P23 connectors.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD VOLTAGE SPECIFICATION TABLETester Connection Condition Specified Condition P22-1 (UP) - P23-2 (U) Always Below 1 Ω P22-11 (DN) - P23-1 (D) Always Below 1 Ω P22-1 (UP) - Body ground Always 10 kΩ or higher P22-11 (DN) - Body ground Always 10 kΩ or higher
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
