Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Floor Shift Assembly: Installation

INSTALL FLOOR SHIFT LEVER ASSEMBLY
1. Install the floor shift lever assembly with the 6 bolts.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
2. Connect the connector to the floor shift lever assembly.
  
  Fig 1: Locating Floor Shift Lever Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Shift into the N position.
2. Connect the No. 1 floor shift gear shifting rod and connecting rod swivel with the nut.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER
1. Install console panel sub-assembly upper (see INSTALLATION ).
  
  Fig 2: Locating Floor Shift Gear Shifting Rod Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.