Inspection Procedure

HINT:

• The detection of DTC P0505 may also be caused by: 1) the floor carpet overlapping onto the accelerator pedal, causing the accelerator pedal to be slightly depressed (throttle position to be slightly open); or 2) the accelerator pedal not being fully released.
• Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0505) 
   1. Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
   2. Turn the ignition switch ON.
   3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   4. Read the DTCs.

      HINT:

      If any other codes besides P0101 are output, perform troubleshooting for those DTCs first.

      Result 

      RESULT REFERENCE
      
      

      Display (DTC output)	Proceed to
      P0505	A
      P0505 and other DTCs	B

      HINT:

      If any DTCs other than P0505 are output, troubleshoot those DTCs first.

   B: GO TO RELEVANT DTC CHART 

   A: Go to next step 

2. CHECK CONNECTION OF VENTILATION HOSE 

   OK: 

   Ventilation hose is connected correctly and is not damaged. 

   NG: REPAIR OR REPLACE VENTILATION HOSE 

   OK: Go to next step 

3. CHECK AIR INDUCTION SYSTEM 
   1. Check for vacuum leaks in the air induction system.

      OK: 

      No leakage from air induction system. 

   NG: REPAIR OR REPLACE AIR INDUCTION SYSTEM 

   OK: Go to next step 

4. CHECK THROTTLE VALVE 
   1. Check the throttle valve condition.

   NG: REPLACE THROTTLE BODY 

   OK: REPLACE ECM