2007 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Repair and Diagnosis: Electrical: Horns: Inspection

  1. INSPECT FUSE (HORN) 
    1. Measure the resistance of the HORN fuse.

    Standard resistance: Below 1 Ω 

    If the result is not as specified, replace the fuse.

    Fig 1: Inspecting Fuse (Horn)
    G04065583Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT LOW PITCHED HORN ASSEMBLY 
    1. Apply battery voltage and check the operation of the horn.

    OK 

    MEASUREMENT CONDITION CHART

    Measurement Condition Specified Condition
    Battery positive (+) --> Terminal 1
    Battery negative (-) --> Horn bracket
    Horn sounds

    If the result is not as specified, replace the horn assembly.

    Fig 2: Inspecting Low Pitched Horn Assembly
    G04065584Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT HIGH PITCHED HORN ASSEMBLY 
    1. Apply battery voltage and check the operation of the horn.

    OK 

    MEASUREMENT CONDITION CHART

    Measurement Condition Specified Condition
    Battery positive (+) --> Terminal 1
    Battery negative (-) --> Horn bracket
    Horn sounds
    Fig 3: Inspecting High Pitched Horn Assembly
    G04065585Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If the result is not as specified, replace the horn assembly.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.