2007 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

VVT Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. DRAIN ENGINE COOLANT (See  REPLACEMENT  ) 
  3. REMOVE INTAKE MANIFOLD ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE VVT SENSOR (for Bank 1) 
    1. Disconnect the connector.
    2. Remove the bolt and sensor.
  5. REMOVE VVT SENSOR (for Bank 2) 
    1. Disconnect the connector.
    2. Remove the bolt and sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.