Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE
Transmission Wire: Inspection
- INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Measure the resistance of the transmission wire.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection ATF Temperature Specified Condition 8 (OIL) - 9 (E2) 10°C (50°F) 5.8 to 7.1 kΩ 8 (OIL) - 9 (E2) 25°C (77°F) 2.5 to 4.5 kΩ 8 (OIL) - 9 (E2) 110°C (230°F) 231 to 263 Ω HINT:
If the resistance is not within the specified range of any of the ATF temperatures shown in the table above, the driveability of the vehicle may decrease.
- Measure the resistance of the transmission wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.