2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Floor Shift Assembly: Disassembly

  1. REMOVE SHIFT POSITION INDICATOR 
    Fig 1: Locating Shift Position Indicator Hooks
    G04948530Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 screws and detach the 3 hooks. Then remove the shift position indicator from the rear console upper panel.
  2. REMOVE CONTROL POSITION INDICATOR PLATE 
    Fig 2: Locating Control Position Indicator Plate Claw
    G04948531Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using a small screwdriver, detach the claw and remove the indicator plate.
  3. REMOVE SHIFT LEVER CAP 
    1. Detach the 2 claws and remove the shift lever cap.
  4. REMOVE POSITION INDICATOR LENS 
    Fig 3: Identifying Shift Position Indicator Claws
    G04948532Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using a small screwdriver, detach the 4 claws and remove the lens from the shift position indicator.
  5. REMOVE POSITION INDICATOR SLIDE COVER 
    Fig 4: Identifying Position Indicator Slide Cover
    G04948533Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the position indicator slide cover from the shift position indicator.
    2. Remove the No. 2 slide cover from the slide cover.
  6. REMOVE SHIFT LOCK RELEASE BUTTON 
    Fig 5: Locating Shift Lock Release Button
    G04948534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using a small screwdriver, detach the claw and remove the button.
  7. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY 
    Fig 6: Locating Indicator Light Wire
    G04948535Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the connector clamp.
    2. Using a small screwdriver, detach the 2 claws and remove the wire.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.