2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Precaution for Brake System

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  • Clean dust on front brake and rear brake with a vacuum dust collector. Do not blow with compressed air.
  • Recommended fluid is brake fluid "DOT 3".
  • Never reuse drained brake fluid.
  • Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.
  • Use clean brake fluid to clean or wash all parts of master cylinder and disc brake caliper, etc.
  • Never use mineral oils such as gasoline or kerosene. They will ruin rubber parts of the hydraulic system.
  • Use flare nut torque wrench when installing brake tube.
  • When installing brake tube and hose, be sure to check torque.
  • Before working, turn ignition switch OFF and disconnect connectors of ABS actuator and electric unit (control unit) or battery cable from the negative terminal.
  • Burnish the brake contact surfaces after refinishing or replacing rotors, after replacing pads, or if a soft pedal occurs at very low mileage. Refer to "BRAKE BURNISHING PROCEDUREΒ ".
WARNING:
  • Clean brake pads and shoes with a waste cloth, then wipe with a dust collector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.