2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

1UR-FSE Engine Mechanical: Equipment

EQUIPMENT CHART

Air gun -
Bar ΓΈ5 mm (0.02 in.) V-ribbed belt tensioner
Brush -
Caliper gauge -
Chain block -
Compression gauge -
Container -
CO/HC meter -
Cutter (45Β°) -
Cutter (30Β°) -
Cutter (60Β°) -
Cylinder gauge -
Engine stand -
Engine lifter -
Dial indicator -
Dial indicator with magnetic base -
Dye penetrant -
Groove cleaning tool -
Hand-lap -
Heater -
Magnetic finger -
Micrometer -
Pin ΓΈ1.0mm (0.039 in.) No. 2, No. 3 chain tensioner
Piston ring compressor -
Piston ring expander -
Plastigage -
Prussian blue -
Reamer 5.5 mm -
Ridge reamer -
Rod aligner Connecting rod
Solvent -
Spring scale Timing chain
Steel square -
Straightedge -
Tachometer -
Timing light -
Thermometer -
Torque wrench -
"TORX" socket wrench (E6) Cylinder head
"TORX" socket wrench (E8) Cylinder head
Vernier caliper -
V-block -
Wooden block -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.