2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Brake Pedal Stroke Sensor: Installation

NOTE: While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/ close the doors while the battery is connected.
  1. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY 
    1. When installing a new brake pedal stroke sensor assembly:
      NOTE:
      • Do not break the sensor lever set pin before installing the brake pedal stroke sensor with the bolts.
      • If the sensor lever set pin breaks while tightening the bolt, do not use that sensor.
      1. Connect the sensor connector.
        Fig 1: Identifying Sensor Lever With Brake Pedal Groove
        G04949805Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Install a new sensor with the 2 bolts.

        Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

        NOTE:
        • Engage the sensor lever with the brake pedal groove.
        • Check that there is no foreign matter attached to the contact surface of the sensor.
        • Check that the tip of the sensor lever is protruding from the brake pedal groove.
      3. Firmly depress the brake pedal and break the sensor lever set pin.
      4. Remove the broken lever set pin.
    2. When reusing the brake pedal stroke sensor assembly:
      1. Connect the sensor connector.
      2. Temporarily install the sensor with the 2 bolts.
        Fig 2: Identifying Sensor Lever With Brake Pedal Groove
        G04949806Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.