Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE
Brake Actuator: Installation
NOTE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/ close the doors while the battery is connected.
- INSTALL BRAKE ACTUATOR NOTE: Do not remove the hole plug before installing a new brake actuator because the brake actuator is filled with brake fluid.
- Install the No. 3 brake actuator bracket to the brake actuator with the 3 bolts.
Torque: 9.3 N*m (95 kgf*cm, 82 in.*lbf)
- Install the No. 3 brake actuator bracket to the brake actuator with the 3 bolts.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.