Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Power Mirror Control System: Precaution

NOTICE FOR INITIALIZATION

NOTE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

SYSTEM NAME CHART

System Name	See procedure
Navigation System (for DVD)	INITIALIZATION
Advanced Parking Guidance System
Power Trunk Lid System
Rear Door Sunshade System

PRECAUTIONS WHEN USING INTELLIGENT TESTER OR TECHSTREAM
1. When using the intelligent tester or Techstream with the engine switch off to troubleshoot:
  Connect the intelligent tester or Techstream to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
2. After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.