2007 Lexus LS 460FACTORY OEM SERVICE PROCEDURE

Speed Sensor: Installation

  1. INSTALL SPEED SENSOR SP2 
    Fig 1: Locating Speed Sensor NC2 And Bolt
    G04948416Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the speed sensor to the transmission case with the bolt.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    2. Connect the sensor connector.
  2. INSTALL SPEED SENSOR NC3 
    Fig 2: Locating Speed Sensor NC3 And Bolt
    G04948415Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the speed sensor to the transmission case with the bolt.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    2. Connect the sensor connector.
  3. INSTALL SPEED SENSOR NT 
    Fig 3: Locating Speed Sensor Connector
    G04948414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Coat a new O-ring with ATF and install it to the speed sensor.
    2. Using a T30 "TORX" wench, install the speed sensor with the bolt.

      Torque: 6.8 N*m (69 kgf*cm, 60 in.*lbf) 

    3. Connect the sensor connector.
  4. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 
    1. Install the spring and check ball body.
      Fig 4: Identifying Check Ball Body And Spring
      G04948413Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Align the groove of the manual valve with the lever pin.
      Fig 5: Aligning Groove Of Manual Valve With Lever Pin
      G04948421Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the 17 bolts.
      Fig 6: Locating Valve Body Bolts
      G04948422Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

      HINT:

      Each bolt length is indicated below.

      Bolt length: 

      21 mm (0.83 in.) for bolt A 

      31 mm (1.22 in.) for bolt B 

      64 mm (2.52 in.) for bolt C 

    4. Install the detent spring and detent spring cover with the bolt.
      Fig 7: Locating Bolt, Detent Spring Cover And Detent Spring
      G04948411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.