Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Shift Lever Assembly: Adjustment

ADJUST SHIFT LEVER POSITION
1. Remove the nut and disconnect the shifting rod.
  
  Fig 1: Identifying Shifting Rod Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the control shaft lever of the park/neutral position switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
3. Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.
  NOTE: Do not push the shift lever too hard.
4. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.
  
  Fig 2: Identifying Moving Shift Lever To N Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.