Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Torque Specifications
BRAKE - TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
|---|---|---|---|---|
| Bleeder plug | 11 | 110 | 8 | |
| Brake booster clevis lock nut | 26 | 265 | 19 | |
| Brake pedal sub-assembly set bolt | 21 | 214 | 16 | |
| Stop light lock nut | 17 | 170 | 12 | |
| Brake pedal support assembly x Body | 12.7 | 130 | 9 | |
| Brake master cylinder x Brake booster | 12.5 | 127 | 9 | |
| Brake line union nut | 15 | 155 | 11 | |
| Wheel nut | 103 | 1,050 | 76 | |
| Front disc brake cylinder mounting x Steering knuckle | 4GR-FSE | 78 | 799 | 58 |
| Disc brake cylinder assembly x Steering knuckle | 2GR-FSE | 78.4 | 800 | 58 |
| Front disc brake cylinder assembly x Front disc brake cylinder mounting | 4GR-FSE | 34 | 350 | 25 |
| Front disc brake cylinder assembly x Flexible hose | 4GR-FSE | 30 | 310 | 22 |
| 2GR-FSE | 39 | 400 | 29 | |
| Rear disc brake cylinder mounting set bolt | 54 | 551 | 40 | |
| No. 1rear disc brake cylinder support pin x Rear disc brake cylinder slide bushing | 25 | 250 | 18 | |
| Rear disc brake cylinder assembly x Flexible hose | 30 | 310 | 22 | |
| No. 3 engine room relay block x Body | 12.5 | 127 | 9 | |
| Brake actuator assembly x Bracket | 5.5 | 55 | 48 in.*lbf | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
