2007 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2007 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
POWER STEERING TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft*lbf
Steering wheel set nut 50 510 37
Steering rack end x Steering rack 76 (103) 775 (1,050) 56 (76)
Power steering link assembly set bolts (for 2WD) 118 1,200 87
Power steering link assembly set bolts (for 4WD) 102 1,038 75
Power steering earth wire x Power steering link assembly 5.0 51 44 in.lbf
Earth wire x Bracket 8.0 82 71 in.lbf
Tie rod end x Steering knuckle 65 663 48
Steering rack end sub-assembly x Tie rod end 56 570 41
Steering intermediate shaft assembly No.2 x Power steering link assembly 35 360 26
Negative battery cable x Battery 5.6 57 50 in.lbf
Positive battery cable x Battery 5.6 57 50 in.lbf
Battery clamp set nuts 2.9 30 26 in.lbf
Power steering ECU assembly set bolts 5.0 51 44 in.lbf
( ): For use without SST
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.