Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2007 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
CRUISE CONTROL TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Cruise control main switch x Steering wheel | 1.7 to 3.0 | 17 to 31 | 15 to 27 in.*lbf |
| Distance control ECU x Body | 5.5 | 56 | 49 in.*lbf |
| Millimeter wave radar sensor x Body | 5.5 | 56 | 49 in.*lbf |
| Clutch switch x Clutch Pedal | 15.7 | 160 | 12 ft.*lbf |
| Cowl side junction block x Instrument panel reinforcement | 8.0 | 82 | 71 in.*lbf |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.